Ring Size at Home | Rahul Gems

Introduction:
Finding the perfect ring size is essential to ensure your jewelry fits comfortably and securely. This guide will walk you through the process of measuring your ring size using a piece of metal wire.

Materials You’ll Need:

• A piece of metal wire or thread (about 4 inches or 10.16 cm long)
• A ruler
• A pair of scissors
• The Ring Size Chart (provided later in the guide)

Step 1: Prepare the Materials:
Gather all the materials mentioned above.

Step 2: Cut the Piece of Wire:
Using the scissors, cut a piece of metal wire that is about 4 inches (10.16 cm) long.

Step 3: Wrap the Wire Around Your Finger:
Wrap the piece of metal wire around the base of the finger you want to measure. Make sure it’s snug but not too tight. It should comfortably slide over your knuckle.

Step 4: Cut the wire at the Overlapping Point:
Cut the wire where it overlaps. The resultant ring of wire shouldn’t overlap. Now check if this ‘ring’ is comfortable to you. It shouldn’t slip, it shouldn’t be too tight. A little tighter ring size would be preferred over loose one, as ring once made cannot be tightened, but can be loosened to certain extent.

Step 5: Measure the Length:
Carefully remove the piece of metal wire from your finger and lay it flat. Use the ruler to measure the length from the end of the wire in millimeters (mm).

Step 6: Refer to the Ring Size Chart:
Now, it’s time to match the measured length with the appropriate ring size using the Ring Size Chart provided.